WWZMDiB TFT LCD Touch Display Module SPI Interface for Arduino (2.8", 320x240, ILI9341)

I have purchased quite a few of these and haven’t had any issues. I think I used 8 of them on the last project I built and didn’t have a problem using a single one. I did not use the touch feature so can’t comment on that but otherwise a great screen.

Quick delivery, great packaging, great value. Just what I needed.

This ILI9341 screen did not work out of the box. I could only get a white screen on the display, although the touch screen seemed to work fine. The seller replaced it, and the replacement has worked perfectly so far. As all of these red ILI9341 touch screens must ultimately come from a common source, there is bound to be a bad one occasionally. Satisfied.

For the Arduino Uno, this display is a poor choice. The resolution of 480x320 proves to be too high for the Uno, which is better suited to a 320x240 display. It runs, but screen updates are painfully slow with the Uno. The Resistive Touch functions nicely, but is not as intuitive as the Capacitive Touch found on the majority of mobile devices. The display quality is pretty nice, and provides a good value, albeit better suited for the Raspberry Pi family.The Uno (and most other Arduino) operate at 5V logic levels. Although this display purports to run with 5V, the logic pins want 3V3, which means you'll have to buy bi-directional logic level shifters to shift the voltage between 5V and 3.3V. It MAY run at 5V, but it definitely runs at 3V3. One symptom of overvoltage is a white screen.When using a breadboard, the display and level shifters won't fit the smaller 400-hole boards, so you'll have to use the larger 830-hole breadboard. Even then, these components occupy the majority of the space on 830, so you may require another for the rest of your project.No pins are supplied for the SD Card reader-writer, so you'll have to dig up your own 4-pin header, and solder them yourself to use it. Note, the reader fits is the larger SD cards. Most of us use the smaller MicroSD cards, so an adapter is needed. Many of those SD to MicroSD adapters are poorly made, and can be unreliable.There is nothing in the packaging or printed on the board to tell you the display uses the ILI9488 driver chip. Nor does it come with any documentation or guides to hooking it up. You'll have to go the the internet to find those answers.

Couldn't ask for a better product for my projects!

I really liked that in the mounted position the pin labels are visable. This makes proto-typing easier. There are several vendors for this display but I chose this one for the shortest shipping time.

No matter what driver or firmware I tried, this screen never worked. Just shows a blank white screen. Switched with another brand and that screen worked perfectly. This is junk. Don't waste your money.

Great over all just a lil disappointed that not all pins were preinstalled on display