Combo Exhaust Pipe Mandrel Bend/Header Tubing, 1-1/2 Inch, Pair

For once the product description matched the product received

good quality pipe

Great bends on all mandrel bends, no signs of distortion at all, packaged with a rust preventative coating on tubes and in a plastic bag!

I cut these up and used a pipe stretcher to make connector from headers to side exhaust.

I found this to be the best deal for this product. While not 100% true diameter throughout the bend, it's close enough. The tubing is thicker than a lot of other pipes I've seen. This will make it sturdier though heavier. It has what looks like a sand blast finish that has a thick oily coating so it doesn't rust. It may be a little rough for some applications but is a good substrate for powder coating. Welds decent.

Z950 dual exhaust

I used this kit to make a cat-back exhaust with Borla 2.5" muffler for my 89-Runner. I used two kits, along with a 2.5" section of walker straight pipe and welded everything. Nice quality overall. The bends are pretty consistent and far superior to crust bent pipe you get at parts stores. Keep in mind the OD of the pipe shrinks in the bends; I don't know if there's a way around this.

Very affordable and worked out great for a custom exhaust