T-H Marine JP-4FA-DP Hi-Jacker Fixed Jack Plate - 4"

Much more sturdy than an adjustable jack plate. Holds up my 150 Yamaha 2-Stroke well.Hokes did not match up exactly, so we drilled them out a bit.

it absolutely does give you the rise and set back as advertised as long as you set both the plates and motor at the upmost positions. the only way yours are not being set high enough are that your bolts through the transom are not properly spaced vertically. and that is no fault of the plates but your own. they performed well and solid and looked pretty cool for the money

easy to install just wish the drilling was done to fit 1/4" hardware. calipers showed it just under that so had to run 3/16" so I didn't have to drill out mounting holes. but it really holds up well for my 35hp motor. Cant wait to try it out and see how the offset changes up my boat how it runs in shallow water.

Used these to raise my outboard out of the water a bit. Works well so far. We will see next summer when I get some more use out of it.

These are pretty heavy duty brackets and do what they say they'll do. Didn't completely solve my issues, but that is because I was too conservative on the installation and I can't blame the product there. Don't shy away if you have bolted in smaller motors or motors that don't fit the standard template. It's aluminum so drilling holes to fit isn't hard and there is plenty of metal to give you room to do so, especially for smaller outboards.

Installed on my G3. I have a 9.9 Yamaha 4 stroke. Wanted better clearance for my Triple Shot Transducer. Requires a person with reasonable knowledge for install but I did with common hand tools.

True American workmanship - great service and product. Highly recommended company.Guys and girls - This product is solid piece of aluminium BUT the holes are only drilled to support 3 inches above the transom - for my boat the holes lined up to 2 inches above the transom. This is really no big deal as you drill the extra holes to extend to the advertised height. My drill bit cost me $25 so if your on a budget factor that in - 13 mm drill bit required.Personally I am very happy with the quality of the aluminium and this product suits my needs - Happy boating people.

I give this one star at the moment. I received this jack plate this evening and to my dismay it is different than the advertised picture. Instead of 3 holes on the bottom ( back side) there is one big cutout. Also it is full of scratches. I also noticed when they sit next to each other one is slightly taller than the other with is a huge deal when mounting an outboard level. Ill let my outboard mechanic look at it but I will be calling amazon and may end up returning it. Not a happy customer at this point.