Standard Motor Products VS63 EGR Time Delay Switch

Bought this part to remove the P0403 EGR Circuit A code on my '03 ford escape V6 and it didn't do it. I removed the old one, installed new one, cleared the code, then started it. It came back after 2 minutes of idling. Drove it for 5 miles after that and nothing happened. Not sure how to remove this code since ive replaced this sensor TWICE! Once with this one and the second with a Dorman. Might have to legitimately go to OEM and spend a crap ton of money on a tiny $20 sensor.

Great deal to buy the open box parts!

Worth buying

Installing this EVR solenoid would be a two minute job but I needed to drill out the right side brass bushing that clips over the bracket. The hole was to small. The stud fit through the left side just fine and I tightened the 8mm nut to hold the solenoid in place. So far it appears to be working well. No rough stumble at idle. The box said made in Taiwan so time will tell if the part is quality.

Easy to install great item at a good value

Got this for my 2003 Ford explorer 4.0l after get code P0401 I changed plenty of parts and this seemed to fix the issue!! Which was a rough idle and stalling..... The mounting holes wasn't the same as factory and was little tough putting on since one of the factory holes is elongated to fit bracket

Probably works great on.. Malibu Barbie's convertible maybe(?) since it looks JUST like the freakin part... just smaller. WAY SMALLER. TOO SMALL.There should be a damn law stating that ANY product sold on Amazon HAS to be pictured with a 50 cents or $1 coin next to it for scale to avoid this BS. Inlet/outlet nipples are 1/4 the size of my lines, entire part is about 1/4 the size of the one I accidently broke.This would be perfect if I had a scaled down crown Vic parked at my granddaughter's dollhouse, but on my button actual, adult sized for real car?Nope.Do not buy for an older Ford.

Arrived on time and as described.